Select Page

ADHL-EPOX-LTE

ADHL-EPOX-LTE


 

ADHL-EADHL-EPOX100LTE is highly advanced two-part, 100% solids, epoxy floor coating, and is designed to cure down to zero º C (32 º F) and provide an extremely rapid room temperature cure. Its low viscosity contributes to easy handling, excellent substrate wetting, and the development of strong bonds to a variety of substrates including damp concrete and metals. ADHL-EPOX100LTE cures to blush-free high gloss finish even under cold damp conditions. The coating has good chemical resistance.

 

industry application


ADHL-EPOX100LTE is used for applications in cool weather (fall/winter) where other coating systems would require preheating of the substrate or enclosure and application of external heat for curing purposes.

ADHL-EPOX100LTE is highly recommended for unheated warehouses facilities, which precludes the use of preheating/external heat. ADHL-EPOX100LTE is ideal for hospitals, laboratories, cold rooms, institutional buildings, garage floors, storage areas, and etc.

Advantages


 

  • 100% solids, with low odour, zero VOC’s
  • Excellent rapid cure properties
  • Ideal for applications of non-heated warehouses
  • Excellent adhesion to damp concrete and steel
  • Good wear resistance
  • Good chemical resistance
  • Excellent water spotting resistance
  • Good early moisture resistance; blush free finish
  • Does not contain benzyl alcohol or nonyl phenol

 

Consult Technical Information

Industrial & Residential

Excellent adhesive properties, allowing application on other firm and hard coating, as well as a good bond to the substrate.

Industrial Flooring

Its exceptionally low odor allows the product to be used in areas where other products cannot be used such as shopping malls, hospitals, restaurants, and etc.

Industrial & Residential

Excellent adhesive properties, allowing application on other firm and hard coating, as well as a good bond to the substrate.

Industrial & Residential

Excellent adhesive properties, allowing application on other firm and hard coating, as well as a good bond to the substrate.

Industrial & Residential

ADHL-EPOX-100 is versatile and can be applied as a smooth or non-slip coating, depending on the customer’s requirement.

how to install


EPOXY TOP COAT
COLOR BASE 
CONCRETE FLOOR

  STEP 3


5. Optional : You can spread a broadcast of your choice on the surface so that the broadcast stick to the floor. Once the broadcast is on the surface you will need to backroll it to get a uniform finishe and anti-slip.

6. Apply another 8-mil thick layer of ADH SOLID Epoxy over the entire surface in order to properly shield and seal the broadcast between the said layers. Let it dry and you’re done !

  STEP 2


4. Add your COLORPODS to the ADH SOLID and apply a new 20 to 30 mils thick coat on the entire surface of the floor.

  STEP 1


1. Prepare the concrete floor surface by blast tracking the floor with a DIAMOND TEETH BLADE and by opening the cracks with a V-CUT BLADE. This serves to open the pores of the concrete for coats adhesion. Once completed, vaccum all dust, stones and impurities. It is very important that the floor is spotless.

2. Use ADH SOLID at 8 mils thick on the entire floor surface to fill the cracks in the concrete and use as the basecoat. At this stage, it is important to use the product and not a crackfiller because it will not enter the bottom of the cracks as the ADH SOLID does so well.

3. With a crackfiller, fill the cracks to give a flat surface over the entire floor. Once the product is well applied on the whole surface and no cracks appears, wait until the surface dries. If once dry, there is some imperfection, you can sand the necessary areas until satisfaction. To finish this step, do not forget to vaccum the residue caused by sanding.